TYING A KNOTLESS KNOT

1 Start off by tying a simple overhand loop at one end of the hook length; this loop is the end of the hair and will act as the anchor point for the hair stop which will hold your bait in place.

2 Using a baiting needle thread your chosen bait over the loop and onto the hair then secure it in place with a hair stop.

3 Thread the hook length through the eye of the hook from the back to the front then adjust the length of the hair to suit the hook bait you are using and your requirement. Allow a gap of at least 5 mm from the top of your bait to the bend of the hook but experiment to find what works best.

4 Keeping the hair trapped tightly to the back of the hook take the other end of the hook length and begin to whip it downwards along the shank, trapping the hair beneath a series of tight, even coils.

5 Keep whipping downwards, stopping when the whipping is roughly opposite the point of the hook. How many turns this will require depends upon the shank length of the hook you are using but try to ensure you get a minimum of five or six turns.

6 Once you have completed the turns trap the whipping firmly between finger and thumb and pass the end of the hook length back through the eye of the hook from back to front, ensuring the line comes out from the front of the hook.

7 Gently pulling the hook length tight locks the turns of line against the shank of the hook and completes the knot. You can now tie the other end of the hook length to a swivel or make a loop in it to allow it to be attached to a hook length clip to finish your rig.

Tags: knotless knot