For many years Colin was a senior Angler’s Mail magazine staff man and he has enjoyed a long, interesting journalism career.
He understands match fishing, pleasure fishing, carp fishing – the lot.
Please share this blog on Facebook and Twitter by clicking the icons above.
GET THE BEST OUT OF SPLIT SHOT ON YOUR LINE
SHOTTING patterns are something that many inexperienced anglers get confused about.
Others with more experience even believe that there is a holy grail of shotting patterns, one that catches more than any other. But let’s get this straight…there are just two basic patterns – strung out or bulk down with a dropper.
Start with those two and adapt them to suit the conditions and species and you won’t go far wrong. Strung out shot is when the fish are willing to take bait on the drop, and is probably linked to warmer water fishing more than anything else. Bulk shotting is to get the bait down fast to the deck where the fish are feeding – or to get through smaller fish that might be higher up in the water.
But in both cases you should never wear blinkers. The size of the shot on the line can be varied, where you place them on the line should be changed – even during a session is you are not getting bites or the fish appear to have gone off the feed.
Good anglers learn to experiment and not stick to one pattern or even one depth of water. Also remember that the shot are not there just to cock your float. They are there to help register bites and aid bait presentation.
The flow of the water – even in lakes – the depth, wind and where the fish are feeding must all be taken into account when you shot up.
Here are a few other good tips to follow, which can be especially useful at this time of the year when fish are a bit more finicky and when bait presentation and bite registration become even more important:
- Never put shot on your hooklength. They can weaken the line.
- Always get a shot as close to the hook as possible – even within an inch or two. This is the tell-tale that registers the bites.
- If your float is shotted right but then doesn’t cock properly, strike. A fish has probably intercepted the bait on the way down and held up the shot.
- Count how long it takes each shot to take the float down to the level you set for cocking. Any variation in the time means a fish has the bait.
- Use small shot in groups when possible, rather than big shot. These smaller shot – say No.8s – will give you a much better presentation and will cast better.
- Sometimes a bunch of big shot is useful for pulling a float through with the current, especially if there is a strong upstream wind.
- In rough conditions get as much weight on your line as possible to improve presentation.
- Play around with small shot to dot your float down so the smallest possible bit of it shows. You will be amazed at how many bites you never normally see… a pin head of float showing can register a bite you never knew you had when the float was even just a quarter of an inch out of the water.
- Stots – very similar to Style weights – are great for use on bigger diameter lines as they don’t ping off so easily. They are also good for stringing out as they fall slower through the water, giving bait a much more natural drop.
- Dot your float down level with the water and then smear if with a bit of Vaseline just to lift it out of the surface film. You keep sensitivity but have more float on which to spot bites.
COLIN MITCHELL WILL BE BACK WITH HIS POPULAR PLEASURE FISHING BLOG NEXT SUNDAY.
Like us on Facebook >> AnglersMailMagazine
Follow us on Twitter >> @AnglersMail
Watch Angler’s Mail TV >> AMTV